The zones are (from left to right)- red, white, green, and red zones. There are four zones in the display area of this meter.To Read a 36 Volt Golf Cart Battery Meter A needle in the red zone indicates that you need to recharge your batteries. Push the pedal down as far as you can to observe how far down the needle goes. To best way to read your battery meter, is to drive your golf cart up a hill. Connect 4’s positive terminal to the positive side or the “switched” side of the key switch to make use of the LED function of the meter.Connect 1 to the main battery bank’s positive terminal and 2 to its negative terminal.The digital meters have three terminals in place of two, labelled 1,2 and 4.This will ensure that the gauge is off when the golf cart is not in use.The “switched” side of the key switch has power only when the golf cart is running.Now connect the positive terminal to the positive terminal of the “switched” side of the key switch.Connect the negative terminal to the negative terminal of the main battery bank. An analog meter has a positive and negative connection terminal in each gauge.Generally, there are two types of battery meters that go into a golf cart-Analog and Digital (usually LED). Note: Certain golf cart models will need wires running from the positive and negative terminals on the battery bank to detect the battery bank voltage.Ī different approach would be to measure the input voltage on a golf cart voltage reducer that comes installed in some custom golf carts that have other 12Vaccessories. This signal wire will ensure that your meter starts working only when you turn on your golf cart. Add a jumper from the ignition switch to the tab on the battery gauge’s bottom. Now connect the signal terminal wire on the meter to the ignition.If you’ve connected them properly, the meter should indicate ~48V or 51Vprovided you’ve a fully charged battery*.Connect the wires that you’ve prepared with these wires. A club car precedent model golf cart will have an extra wire set in the wire harness seated behind the dash and the ignition switch.Now, attach the butt connectors and connectors to your wires.Prep the terminals and butt connectors using wire strippers.Prep the end of your wires using crimpers.To install your meter in the dash, you’ll need ~3 pieces of 8-12 inches of wire which are 14-18 Gauges.Holesaw and drill, if you have a round meter.
0 Comments
Leave a Reply. |